Due to the Spring Festival holiday, the handling time and delivery time will be delayed from January 21st to February 9th.
How to install the switch correctly
02.02.2024 | ergokbd |
When installing the switch, the following suggestions are very important.
 
As long as you follow the installation method below, there will be no problem.
 
All operations are to ensure that there will be no physical damage.
 
---------------------------------------------------------------------------------------------------------------------------------------------
 
First, observe whether the pins of the switch are vertical. If the pins are not vertical, please adjust them to vertical first.
 
1. During installation, press your fingers against the shaft seat before installing the switch.
(This operation is to prevent the hot swappable socket from being pushed out. But our keyboards are usually assembled, so we rarely recommend users to do so.)
 
Or:
 
2. Gently place the switch into the installation position, press the switch lightly to ensure there is a key code output, and then press down firmly. Because the key code output indicates that the pins of the switch are accurately inserted into the hot swappable socket.
 
Watch the video link below and then manually install the shaft body, greatly reducing the risk of damage caused by insertion.
 
Link: https://www.bilibili.com/video/BV158VxexEYg/?vd_source=b04d2df79ab70f3478b15b999e6e79a3
 
Key code test connection in the video
https://config.qmk.fm/#/test
 
(The switch does not need to be fully installed on the positioning board to trigger. When the pins of the switch are located in the hot swappable socket, they can touch the metal clip of the hot swappable socket to trigger.
 
So you just need to place the switch in the correct position, gently press it(No need to plug it all in), and if the key code can be output, it means that the pin is inserted correctly. At this point, you can press it down firmly to complete the fixation.
 
On the contrary, if lightly pressing the switch does not output, please remove the switch, adjust its position, and repeat the operation until it can output, and then install it with force. We usually recommend users to do so.)